| Software Features | PC requirement | FAQ & Support | Software updates | Ordering |
Live View from Taiwan 12-14 hours ahead of North America (Use password: 1111) |
Introduction
Users may scheme a desired schedule for carrying out the following commands including Recording, Telephone/Pager, I/O Control, Remote Monitoring, and Sending Signals to Geo-Center. In order to set up an advanced schedule, users sometimes have to break down time frames for schedule set up. Schedule Set Up It is recommended that users think vertically instead of horizontally. The software is designed to perform multi-time frame setup schedule. Users may set up schedule by breaking time into a minimum unit of 15 minutes. Setting up a schedule is quite simple and can be accomplished by the following steps listed next. Desired Schedule Calendar You wish to carry out a whole week schedule : Tuesday, 8:00-19:00 Step-by-Step Instructions Let's take Tuesday as an example: only from 12:00-13:00 all five commands must be executed, I/O Monitoring is scheduled to execute from 10:00-13:00 and Remote Monitoring is scheduled to execute from 11:00-14:00...etc. Thus, the schedule set up must be carried out step by step and break down into different time units. Step 1: You have to set the starting time from 10:00 to the ending time 11:00 and click I/O control in order to activate I/O control. Step 2: You have to set the starting time from 11:00 to the ending time 12:00 and click both I/O control and Remote Monitoring in order to activate the two functions Step 3: you have to set the starting time from 12:00 to the ending time 13:00 and click all commands including Recording, Telephone/Pager, I/O Control, Remote Monitoring, and Sending Signals to Geo-Center in order to activate all five functions. Step 4: You have to set the starting time from 13:00 to the ending time 14:00 and click four commands including Recording, Telephone/Pager, Remote Monitoring, and Sending signal to Geo-Center in order to activate the four functions. Step 5: You have to set the starting time from 14:00 to the ending time 15:00 and click Sending Signals to Geocenter in order to activate Sending Signal to Geo-center function. Final Setup Schedule Note: After performing the above procedures, you should have completed your schedule set up for Tuesday. Continue to set the schedule for any other days during the week by using the same technique. |
